The ABAX FMT100 unit is designed to be an easy two wire installation that can be fitted on top your battery in minutes
The unit requires power from a constant 12V or 24V powersource, such as the vehicle battery or, for example, a jump-start point.
It is the customers responsibility to ensure the unit is mounted correctly. ABAX will not cover the costs to replace or swap a unit that is faulty due to an incorrect installation. Failure to mount the unit according to ABAX guidelines may also void your lifetime warranty.
Dimension: 92,5x57,6x14mm
Weight: <63g
Supply voltage: 10 to 30 V DC
IP65K
GPS accuracy: 2,5 meter
Temperature resistant: (-40°C to +85°C)
Sensors: accelerometer
GNSS antenna
Easy installation
Read the ABAX FMT100 datasheet for further specifications
For practical, aesthetic and security purposes, the best installation location for ABAX FMT100 device is on top of the vehicle’s battery.
Locate the battery in your vehicle.
If present, remove the battery cover to access the battery terminals.
Decide on a mounting position – the best position is usually on top of the battery with the wires pointing out to the front of the vehicle.
Remember to check that the cables can reach the battery terminals.
Clean the area with the cleansing wipe provided and use a paper towel to dry off.
Peel off the double-sided tape and mount the device to your desired location.
Fasten the red wire to the positive vehicle battery terminal and the black wire to the negative vehicle battery terminal. Ensure the terminals are firmly refastened.
If the device is receiving power, the LED will blink.
To finish, make a note of the vehicle registration number, vehicle mileage and the main driver - give these details to your administrator together with the device serial number which is located on the box.
| Installation type: | Concealed |
| Estimated installation time: | 10 minutes |
| Required tools: | Flat head screwdriver, 10mm and 13mm socket drive |
| Red wire: | For permanent power |
| Black wire: | For ground (earth) |
